Ready-built circuits
14 example circuits, ready to simulate
Open any example on the 3D workbench, run it, change it and see the effect.
Pneumatics
- Direct control · single-acting — A 3/2 push-button valve extends the single-acting cylinder; on release the spring retracts it. Hold the green button.
- Indirect control with memory — S1 pilots 14 and S2 pilots 12 of a bistable 5/2 valve. The flow control valve on the exhaust (meter-out) sets the extension speed.
- Automatic cycle with roller valves — With the selector switch on, the cylinder oscillates: roller valve A0 (retracted) AND selector → 14; roller valve A1 (extended) → 12.
- Timed return (pneumatic) — S1 extends the cylinder; at the end position the roller valve A1 feeds the time-delay valve, which pilots the return after the delay.
- Cascade A+ A− B+ B− — Two cylinders in the sequence A+ A− B+ B− with a 3-group cascade (GR.1 A+, GR.2 A− B+, GR.3 B−). Two memory valves switch the group lines; the roller valves a0, a1, b0, b1 are supplied from the group lines. Press start (Shift+click for continuous cycles).
Electropneumatics
- Direct electropneumatic control — Momentary button S2 energises coil Y1 of a 5/2 single solenoid valve: the cylinder extends while the button is held.
- Relay latching circuit — S2 starts, S3 stops (stop dominant). K1 holds itself via contact 11–14; contact 21–24 drives Y1 and 31–34 lights H1.
- Continuous cycle with sensors — Detented S1 starts the cycle. B1 (retracted) via K1 drives Y1; B2 (extended) via K2 drives Y2 of the 5/2 double solenoid valve.
- Timed return (time relay T1) — S2 extends (Y1). When B2 detects the end position, T1 counts 2 s and contact 15–18 drives Y2 to retract.
- A− B+ A+ B− with VMPA valve terminal — Two cylinders driven by the two bistable slices of the VMPA terminal (coils 2-14 / 2-12 for A, 3-14 / 3-12 for B). A starts extended. S2 START latches K1 → A− ; sensor A0 (via K1) → B+ ; sensor B1 energises K2, which drops K1 and gives A+ ; sensor A1 (via K2) → B−. S3 extends A by hand (home position).
- Cycle counter — Continuous cycle that stops after 3 cycles: the counter NC contact 11–12 interrupts Y1. S2 resets the counter (R1/R2).
Hydraulics and electrohydraulics
- Hydraulics · 4/3 hand lever valve — Power unit, distributor with gauge, closed-centre 4/3 valve and flow control on the extend line. Click the lever.
- Electrohydraulics · 4/3 solenoid valve — S2 drives Y1 (extend), S3 drives Y2 (retract). Without a signal the valve centres and the cylinder stops where it is.
Combined workstation
- Mechatronics · pneumatic clamp, hydraulic press — Combined workstation. Switch S1 on: the pneumatic cylinder clamps the part; its end-position sensor energises the 4/2 solenoid valve and the hydraulic cylinder presses. S1 off: both return.
Build your first circuit in two minutes — free, in the browser.Open the 3D workbenchPlans and pricing